7.PWM is connected to the motherboard FAN CPU interface through the PWM CONNECTION cable,.

Scope of application: motherboard 4-pin interface.

Product model: temperature control 4-pin hub.

Fan interface: IDE interface, support 3/4 pin.

Package content: 1 x 12V 10 way 4-pin ide fan governor, 1x PWM connecting cable. If the chassis fan is configured in BIOS to run at 50%, you will have 10 fans at 50%. The ten fans will spin at the same speed, that designated by the system for that fan. You can connect to the CPU fan lead on the system board or the chassis fan lead. So, the hub has a power source fed from the computer power supply, then the speed is regulated by the speed for the 'source' fan. RED is expected to be a pass through for the CPU fan.Also a fixing screw hole in the middle of the PCB to facilitate fixing to a part of the chassis. There is EVA double-sided adhesive at the back of the hub, which can be easily affixed to a flat place.

3Pin fan can also be used, but because 3Pin has no PWM function, it is at fixed speed after inserting. Please note 4Pin fan speed can be adjusted by temperature control. Since the mainboard can only receive one rotation speed signal, the remaining nine conventional fan interfaces have the PWM function, but no speed signal. In the hub interfaces, the RED CPU interface is the CPU fan dedicated interface (with speed detection function).Designed for 12V 4-Pin 3-Pin fans, support simultaneous starting at most 10 channel fans. Expand 4-pin fan interfaces, solving the problem of lack of motherboard fan interfaces.

4 pin fan controller